Tomy – FDSSTICK Home Page

The latest FD3206 modchip v4 (no need any wires)

August 21, 2022September 5, 2022 Tomy

It is so easy to install. Just plug over FD3206 chip. Then solder 8 points. No need any wires and no need to cut any wires from PCB. It support all the device, fdsstick, fdsemu, MGD1, copymaster, disk hacker, Tonkachi Editor ….
Buy it here : http://www.tototek.com/store/index.php?main_page=product_info&cPath=1_35&products_id=228

FDS 3206 Mod Chip v3

October 9, 2018October 9, 2018 Tomy

It is latest Modchip for 3206 drive. No need to cut any wires from the drive board. It is fully support fdsstick read/write disk.
http://www.tototek.com/store/index.php?main_page=product_info&cPath=1_35&products_id=207

FDS 3206 Mod Chip v2, working on fdsstick now

February 16, 2016October 9, 2018 Tomy

Just want to let you guy know, if you want to mod your 3206 drive for use on fdsstick. Then you *MUST* use 3206 Mod Chip v2.
http://www.tototek.com/store/index.php?main_page=product_info&cPath=1_35&products_id=143
Also, you *MUST* use latest software from fdsstick site.
At least use this version : http://3dscapture.com/fdsstick/FDSStick_20160214.exe

If you use V1 chip on fdsstick, then you can not read or write. Also, when you read disk, it will format your disk. I’m sorry about that. But V1 chip had been released before fdsstick. I don’t know it is not compatible with fdsstick.

3206 modchip with fdsstick

November 15, 2015 Tomy

I confirm 3206 modchip is not compatible with fdsstick read/write.
When it is develop, fdsstick haven’t appear. So, I can’t know that.
It is working good except fdsstick. Like Copy Master 1.1, Disk Hacker else.
Also, it can work with any fds game with save function like Zelda.

I’m finding a way to make it compatible with fdsstick. But need some times.
I will check what different with Copy Master and fdsstick read/write.
Hope will fix soon. Sorry.

fdsstick read error fix (maybe?)

October 9, 2015November 15, 2015 Tomy

News from loopy :
On read errors – I’ve found that a series resistor (10k or so) on the READ DATA pin (“pin 9” in my pinout diagrams) helps.

I built a GUI, it’s not quite finished but you can try it out. http://3dscapture.com/fdsstick/FDSStick.exe
I made a small change to the firmware to make using the button easier. Instead of slot numbers, you push the game number (1, 2, 3, etc..). After the game loads, the button changes disk sides (1=A, 2=B, …)